Before installation, the constructor should inspect whether the hollow anchor bar and the water hole are unblocked. If blocked, clear up in time.
After the anchor bolt is drilled into the designed depth, the hole should be washed by water or air till the water or air is returning from the bottom. Only at this moment, should the plate and nut be installed in time to fix the hollow anchor bar temporarily.
The grouting material had better be pure cement paste or cement mortar in which the proportion of the cement and sand is 1:1 and the proportion of the cement is 0.4~0.5. When adopting the cement mortar, the diameter of the sand should not be bigger than 1.0mm.
The grouting material should be injected through the hollow anchor bar and when the intensity of the cement mortar reached 5.0 Mpa, the nut can be tighten.
